This gives you all the programming information in one place to facilitate the programming process. Be sure to circle where each zone resides:

Use Table 5 on page 7 to record zone assignments and settings. These settings appear in segments of each programming location. When programming wireless transmitters into the receiver, you can set various options and partitions for each transmitter. If a hardwire input (on either the control panel or hardwire expander) is also present on the same zone as an enabled wireless zone, the wireless transmitter takes priority. All other control panels can have wireless zones added to any zone.All zone expansion modules must not overlap any blocks of 8 zones. To do this you must disable the onboard control panel zones in panel location 37.

NX-8 control panels can have expansion zones (hardwire or wireless) set the same as those contained in the control panel.NX-4 and NX-6 control panels can have receivers added with zones that overlap those contained in the control panel.Use the following programming guidelines:

This section describes how to program the units. 4 NetworX NX-548E Receiver Installation Instructions

Default code for ge networx nx6